Sunday, 16 April 2017

New Spindle's first cut - Episode 144



This is the first run of the new spindle. New and improved with start, stop and speed under software control. Hadn't intended to go this far with the build but things got away on me and before I knew it I had built a new controller housing for the VFD and moved my Gecko drive and UC300ETH into it as well.

https://youtu.be/Yd-eptUKug0

Thoughts

The auto start is going to take a bit of getting used too.
Other than that it is looking good.
 




 

No comments:

Post a comment