I will also how how I made the files that allowed me to machine a piece of stock longer than my Table top by rotating the stock 180 degrees.
Where did I get the cutters for this project?
The cutter I used were purchased from this supplier on Ebay
http://ebay.to/2xienoR
Other ebay suppliers of 1/8" down cutting bits.
http://ebay.to/2zfwxYY
They are 1/8" in diameter single flute down cutting spiral bits.
The length of the cutting edger is 10mm ( 3/8") but anything similar eg 12mm(1/2") cutting edge would work just as well. There is little point having a longer cutting edge unless you are looking to cut your material in one pass. The flute area is weaker than the main shaft so a longer flute just weakens the cutter in my opinion. In fact since I do not cut more than 1/8th per pass any flute longer than 1/4" is a waste.
How much Plywood So how much 1/2" plywood was used to make this project?
How easy did it go together?
It went together a dream. I really thought I was going to have to fight it and round all the corners on my parts to make them fit. Much to my surprise it didn't require it. It makes me feel happier about attempting another project in the future.
More photos of the train
How big was the train?
66" long (5' 6")
11" wide
25" high
Not sure there is much more to be said except thanks for watching and I'll see you next time.
Cheers
Peter
